First it sounds like you are collecting octets and out octets. These arent
expressed as a percentage. Assuming you are using these MIB variables in
some type of expression, a full duplex circuit could give you "utilization"
greater than 100%. A T1 gives you 1.544E6 bps in BOTH directions. Try
setting up 2 collections (in and out) for this link.
I hope this helps. I didnt fully understand the question.
Bryan
> ----------
> From: Fransiscus Wahyu[SMTP:wahyuh@UT.ASTRA.CO.ID]
> Reply To: Discussion of IBM NetView and POLYCENTER Manager on NetView
> et alia
> Sent: Monday, August 03, 1998 9:40 PM
> To: NV-L@UCSBVM.UCSB.EDU
> Subject: Utilization
>
> I have collected utilization from Data Collection (in Octets & Out
> Octets)
> and sometimes I found that utilization for one device was over 100 %
> Is it possible ? if it is possible , why this is happen ?
>
> Thank You
> Wahyu
>
|