You need to check the system.sysObjectID against what is defined in the
oid_to_type and the oid_to_sym files, its a exact match. Also check to see
if you are getting any error messages when you run ovw_fields and
ovw_config, with regards to cisco devices or symbols. Once you are sure
that all the configuration files are correct, you do need to stop all GUI's
and restart them. The reason is that all the symbols are put into memory
when the GUI is start, and this memory is not refreshed until the GUI is
restarted.
Tivoli Verification - RTP
Bldg 500, 4205 South Miami Blvd, Research Triangle Park, NC 27709
Email: mark.sklenarik@tivoli.com Http: www.tivoli.com
Peter Hadamovsky <phadamov@DEBIS.COM> on 12/10/98 07:01:36 AM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on
NetView <NV-L@UCSBVM.UCSB.EDU>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: Mark Sklenarik)
Subject: Cisco-Router
Hi folks,
Just a wee question today:
We got some "brand new" cisco routers 2611 and 2612 into our network
(and netview)!
NetView discovers them, but is not able to show an other symbol than an
ordinary gateway symbol!
Looking onto the machine says nothing in the vendor entry - but it says
the IOS version and so on!
I got the newest bitmap files,
edited the files in /usr/OV/fields/C
cswk_fields
c2600_fields
snmp_fields
/usr/OV/conf/C
oid_to_symbol
Any ideas which MIB I do need, that this router gets fully resolved?
Thank you very much for your help!
Peter Hadamovsky
|