Michael Tsai
ITAP-SSR-RS/6000 & AIX,
Availability Service
IBM Taiwan Corporation,
206, Sec. 1, Keelung Rd., Taipei, Taiwan, R.O.C.
Tel: 886-2-7259365, Fax: 886-2-7201499
Notes ID: MICTSAI/Taiwan/IBM, Internet ID: mictsai@tw.ibm.com
---------------------- Forwarded by Michael Tsai/Taiwan/IBM on 99/03/01
08:25 AM ---------------------------
Michael Tsai
99/02/28 10:52 PM
To: nv-l@ucsbvm.ucsb.edu
cc:
From: Michael Tsai/Taiwan/IBM @ IBMTW
Subject: 8260 port traffic/utilization monitoring
Hello,
I installed Neview V5.0 for AIX, and also Nways Mgr for AIX V1.2.1
(Campus Mgr for Lan), I am trying to monitor 8260 each slot/port
traffic respectively, I knew that I can use Nways Campus Mgr for
lan to monitor 8260 port traffic what I expected, but it should operate
by Nways Mgr interface, not thru Netview interface, in other words,
I can not check/review 8260 interface traffic thru standard MIB-II
flow, which meant there is no standard MIB-II value can be discovered
by Netview interface, my question is:
can I review/check those private MIB value which collected from
8260 slot/port traffic data thru Netview interface, if I already installed
Nways Campus Mgr for LAN ? if not, can I also locate them by command
line?
Michael Tsai
ITAP-SSR-RS/6000 & AIX,
Availability Service
IBM Taiwan Corporation,
206, Sec. 1, Keelung Rd., Taipei, Taiwan, R.O.C.
Tel: 886-2-7259365, Fax: 886-2-7201499
Notes ID: MICTSAI/Taiwan/IBM, Internet ID: mictsai@tw.ibm.com
---------------------- Forwarded by Michael Tsai/Taiwan/IBM on 99/02/28
10:38 PM ---------------------------
Michael Tsai
99/02/25 07:04 PM
To: nv-l@ucsbvm.ucsb.edu
cc:
From: Michael Tsai/Taiwan/IBM @ IBMTW
Subject: 8260 port traffic/utilization monitoring
Hello,
I would like to seek for someone help for following inquiries:
1.can Netview monitor 8260 switch module(8271-F3S) per port traffic?
(ifinoctects or ifoutoctects)
2. can Netview monitor 8260 lan module(20 port or 40 port) per port
traffic?
if yes, is this a standard MIB value? or a private MIB?
3. I'm trying monitor 8260 all lan/switch module per port
traffic/utilization
via Netview API, is this possible? or , is there any tool to do it?
or 3rd party SW product?
Michael Tsai
ITAP-SSR-RS/6000 & AIX,
Availability Service
IBM Taiwan Corporation,
206, Sec. 1, Keelung Rd., Taipei, Taiwan, R.O.C.
Tel: 886-2-7259365, Fax: 886-2-7201499
Notes ID: MICTSAI/Taiwan/IBM, Internet ID: mictsai@tw.ibm.com
|