Re: Integrating HP-Openview with Netview/6000

[MICHAEL_IMHOFF@HP-DENMARK-OM1.OM.HP.COM]

     I think you need to configure your traps in NetView as you have done
     in NNM. NNM automatically loads TRAP-TYPES to the trap configurations
     database (which has replace trapd.conf). For NetView you'll need
     mib2trap.


     - Michael.


______________________________ Reply Separator _________________________________
Subject: Integrating HP-Openview with Netview/6000
Author:  Non-HP-W.M.de.Bruin (W.M.de.Bruin@DNB.NL) at HP-Belgium,mimegw3
Date:    25-03-99 08:26


Hi all,

I know it is possible to froward traps from HP Openview to another
management platform, like Netview/6000.
I am currently doing it, but obviously, they appear as "raw" traps, and
need to be formatted in trapd.conf.
Where/how can I get hold of these traps, how do I load them in trapd.conf,
or do I need to get the mibs
and use mib2trap ?

Thanks

Wouter de Bruin
Network Consultant
De Nederlandsche Bank
Externe E-Mail wordt door DNB niet gebruikt voor het aangaan van
verplichtingen
Any e-mail messages from The Nederlandsche Bank are given in good faith but
shall not be binding nor shall they be construed as constituting any
obligation on the part of the Bank