They are discovered as new interfaces, so I guess it's not much I can
do but unmanage them then?
-----Original Message-----
From: Rob Rinear [mailto:robr@DIRIGO.COM]
Sent: Monday, June 14, 1999 4:28 PM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: Interface discovery
Does the new IP show up as a new node, or an additional interface on the
server?
If it's a new node, then add an entry in your seedfile for the RAS IP range,
with a "!" in front, which tells Netview to exclude this range.
If it shows these as interfaces on the server, then the best you'll do is to
allow each address to be discovered once, then unmanage it.
-----Original Message-----
From: Discussion of IBM NetView and POLYCENTER Manager on NetView
[mailto:NV-L@UCSBVM.UCSB.EDU]On Behalf Of Frantsen Christian
Sent: Thursday, June 10, 1999 10:04 AM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Interface discovery
Is there any way of making Netview NOT to discovery my RAS-ip's in an
NT-server i monitor?
Everytime someone dial's in and gets a DHCP-IP i get a new interface that
ends up down :)
Since the RAS is not used very often the interface gets deleted after a time
and then
it gets rediscovered again.
I'm using a seedfile for node-discovery
-----------------------------------------
Christian Frantsen
Internoc Scandinavia AB
Tel: +46-36-194843
Fax: +46-36-194651
|