I took a look at the properties but read-only was not set. Is there a way to
reset trap settings to the default? I would be happy to reenter the execute
commands over again.
Thomas Clarke
Network Operations Engineer
The Island, ECN.
(212)231-5010
----- Original Message -----
From: <James_Shanks@TIVOLI.COM>
To: "IBM NetView Discussion" <nv-l@tkg.com>
Sent: Thursday, August 31, 2000 2:49 PM
Subject: Re: [NV-L] Trap Settings Stuck
>
>
> Go to \usr\ov\conf and select trapd.conf. Right click and check the
Properties.
> Make sure it doesn't say "ReadOnly"
> If that were somehow set outside of NetView it could result in this
problem.
>
>
> James Shanks
> Team Leader, Level 3 Support
> Tivoli NetView for UNIX and NT
>
>
>
> "Thomas Clarke" <tclarke@island.com> on 08/31/2000 01:14:29 PM
>
> Please respond to IBM NetView Discussion <nv-l@tkg.com>
>
> To: "IBM NetView Discussion" <nv-l@tkg.com>
> cc: (bcc: James Shanks/Tivoli Systems)
> Subject: [NV-L] Trap Settings Stuck
>
>
>
>
> Hi all. I'm using Netview 6.0 for NT. I'm having difficutly getting back
> into my traps settings to make changes. I can open them up but according
to
> Netview it is already open somewhere. I've looked in my task manager and
> trap.exe is not running. I cannot make any trap changes. Does Netview lock
> the trapd.conf file in some way that would keep ? I rebooted the computer
> and I'm still getting the Trap Settings Already Open message. This has
never
> happened before.
> Thanx in advance for the advice.
>
> Thomas Clarke
> Network Operations Engineer
> The Island, ECN.
>
> _________________________________________________________________________
> NV-L List information and Archives: http://www.tkg.com/nv-l
>
>
>
> _________________________________________________________________________
> NV-L List information and Archives: http://www.tkg.com/nv-l
|