Chaz,
The extra four could be LoopBack and HSRP? Do an snmpwalk of
ip.ipAddrTable.ipAddrEntry.ipAdEntIfIndex
and
interfaces.ifTable.ifEntry.ifDescr
to double check.
Regards,
Peter Anderson
Senior Communications Analyst
Ph: 0011 61 2 99025938
Any views or opinions presented are solely those of the author and do
not necessarily represent those of Westpac Banking Corporation.
-----Original Message-----
From: Vidal, Chaz
Sent: Wednesday, 22 November 2000 22:39
To: 'IBM NetView Discussion'
Cc:
Subject: [NV-L] All those interfaces
Hi all,
I'm pretty new to network management so I would like to ask your collective
expertise here. Please excuse me if this discussion has been done to death.
Right now, I am not sure if my NV installation is working as designed or
there is something else I need to do.
My installation is NV 6.0 on Solaris. One Cisco router has 23 displayed
interfaces. These are the ones with addresses. I verified this by doing a
Monitor->Network Configuration->Addressses. When I check on the interfaces
using Monitor->Network Configuration->Interfaces, there are 41 discovered
interfaces including serial and E1 links. And when I go to the Monitor->Mib
Values->Interface Info, I get 45 discovered interfaces.
Can anyone explain to me why I get this behavior. And also, how do I get all
45 interfaces displayed in the IP map?
Chaz Vidal
EDS Australia
_________________________________________________________________________
|