In my experience, a demandpoll on an snmp-status-polled node does
indeed check the status of each interface. Instead of showing the list
of interface addresses being pinged at the top of the output, it shows it
further down, by interface index number, with ifAdminStatus and
ifOperStatus
for each interface. If it is not doing this for you, you should call
Support.
If I have not understood the question, please ask again....
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit
echevarria@ES.IBM.COM@tkg.com on 11/27/2000 01:11:09 PM
Please respond to IBM NetView Discussion <nv-l@tkg.com>
Sent by: owner-nv-l@tkg.com
To: nv-l@tkg.com
cc:
Subject: [NV-L] demandpoll in Netview 6.0
Hi all,
I've just tested Netview 6.0 and I found that demandpoll on a
SNMP-polled device is different to demandpoll on a IP-polled device. The
latter polls (with ping) all discovered interfaces but the former doesn't
poll any interface. Does anybody know why it is done like this? advantages?
replacement for missing functions (other than using MIB browser)?
Regards,
Juan
Juan Echevarría López
AT&T Global Network Services
Internet: jechevarria@att.com
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|