You put just the daemon executable on top of your 6.0 system? That's not
what I had in mind. NetView maintenance is produced as a unit, out of a
single build, and newer executables will often not runon old systems. What
I had in mind was that you install all of 6.0.1 off the CD. Takes about 15
-20 minutes.
If that doesn't work, do you get any error messages when you try to run it
from the command line stand-alone?
I have no other hints for diagnosing this. I saw the thing run here. I
started it and the configurator myself in the Verification lab during 6.0.1
testing, so I have seen it work. Worked fine for me. NT is not my
platform of choice, so unfortunately I have no other pieces of advice to
offer. If you cannot get it to run, I would suggest a call to Support.
James Shanks
Team Leader, Level 3 Support
Tivoli NetView for UNIX and NT
Daniel Lehman <dlehman@hurricanetechgroup.com>@tkg.com on 03/30/2001
05:33:19 PM
Please respond to IBM NetView Discussion <nv-l@tkg.com>
Sent by: owner-nv-l@tkg.com
To: nv-l@tkg.com
cc:
Subject: [NV-L] tecad_nv6k daemon now will not start
Took your advice James and put the tecad_nv6k exe on from 6.0.1 and it did
not start, reverted back to the old exe, but to no avail. When i atempt to
start it produces no error and status say NOT_RUNNING. Any advice on where
to look for further indications of the issue. Thanks in advance.
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|