José,
Do you have the right read community string configured for these routers?
Use the "netcheck" command to verify you have SNMP access. After NetView
does a configuration poll and can access the MIB, NetView should realize
these interfaces are on the same box and pull them together. If it cannot
read the MIB then you may be getting what you see. Also, does each node
created have no "symbol", just a blank box? When NetView reads the MIB,
it should also assign a valid map symbol that says what type of device it
is.
Also, I assume that the router has an interface in /etc/hosts or DNS to
give it a valid name at discovery...and that the interfaces for a device
are not in the DNS pointing to different names.
Kind regards,
Stephen Hochstetler shochste@us.ibm.com
International Technical Support Organization - Austin
Office - 512-436-8564 FAX - 512-436-8701
|