That's what the Data Collection function is for. Among the pre-defined mib
expressions you will find both half-duplex and full-duplex bandwidth
utilization. You need to determine which interface is involved in the link,
by index number in the MIB II interface table, and start up data collection
on one end, or both ends. For a link between routers I exect you will
use full-duplex (sum of send and receive divided by the interface speed.)
See the manual, and the online help. The function is under
Tools..MIB..Collect Data.
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit
Simon
Collins/United To: nv-l@lists.tivoli.com
Arab cc:
Emirates/IBM@IBMA Subject: [nv-l] Bandwidth Usage
E
05/06/2002 10:54
AM
Netviewers,
Being new to this product I'm looking for some help pls.
I have a 6.0.2 NT installation and would like to monitor the Bandwidth
Utilization between two routers. Is this possible and could you pls point
me in the right direction.
Thanks in Advance for your help,
Regards,
Simon
_______________________________________
Simon Collins
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
For additional commands, e-mail: nv-l-help@lists.tivoli.com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
|