The Comprehensive Network Address Translation (CNAT) 2.1 package that
now comes with TEC 3.8 says in the Release Notes that there are 2 new
supported configurations:
* Primary CNAT only, with no redundancy, on a system with one or two
interfaces. A CNAT with a single interface is referred to as a
?one-armed router?
CNAT.
* Primary CNAT installed on a NetView 6.x or newer system. Redundancy is not
supported with this configuration, and the CNAT cannot act as a ?one-armed
router? (the CNAT is performing translation for the benefit of NetView
only).
I cannot find any further references in either the Release Notes or the
User's Guide and no entries when searching the IBM Support site.
Does anyone have any further details ojn this "one-armed router" (like
how to configure it) and on using CNAT to perform translation for
NetView only. Why can I not combine the one-armed router with
translating for NetView only?
Many thanks for any input,
Jane
--
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2003 Jane Curry <jane.curry@skills-1st.co.uk>. All rights
reserved.
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
For additional commands, e-mail: nv-l-help@lists.tivoli.com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
|