Hi
You should only put the % in frony of the HSRP address then you have to
reload netmon.
To verify that the HSRP is well configured check in the netmon.trace file.
Cordialement.
Maxime TRANNOY
IGS - Network Delivery Support Center
Tel : +33 (0) 492 114 767
mailto:mtrannoy@fr.ibm.com
"Mark Jacques"
<Mark.Jacques@po.
state.ct.us> To
Sent by: <nv-l@lists.us.ibm.com>
owner-nv-l@lists. cc
us.ibm.com
Subject
[nv-l] Question on Seedfile and
02-06-2004 16:46 HSRP devices
Please respond to
nv-l
Netview 6.0.3 AIX 4.3.3
When entering devices in the seedfile as HSRP should I use both device
names or the virtual ip HSRP address?
Mark Jacques
Department of Information Technology
Enterprise Network Services
101 East River Dr.
East Hartford CT 06108
Phone 860-622-2436
Fax 860-291-8984
mailto:mark.jacques@po.state.ct.us
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* *
This information may be confidential and/or privileged.
If you received this in error, please inform the sender and remove any
record of this message.
Note that messages to or from the State of Connecticut domain may be
subject to Freedom of Information statutes and regulations.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* *
|