Brian,
Is Netview discarding the event or is TEC discarding the event. I have
setup this exact scenario on the same platform as you. It my case, I setup
the new traps that I wanted to go to TEC as a new class, but didn't define
the class in a baroc file on the TEC server.
Also, if these are new traps, have you run the TEC_Config utility to make
sure that they are filtered "IN" ? Again, in our case I not only had to
define the traps in Netview as you have, but as a final step I had to make
sure that those specific traps were filtered "IN" so that the TEC adapter
would "pick them up" and forward them to TEC.
Brian
-----Original Message-----
From: Brian W Green [mailto:brian.green@cgi.com]
Sent: Friday, October 01, 2004 1:48 PM
To: Netview Mailing List
Subject: [nv-l] Trap flow to TEC
I have a Netview server on NT, and I am trying to set up the flow of
traps to TEC. For the traps loaded during the install (there are about
115 of them) the flow works fine, but I am trying to load new traps and
get the flow working. I have edited the enterprise into the
tecad_nv6k.oid file, and edited the .cds and .conf files - but nothing
happens. Looking in the trace file (I edited tecad_nv6k.err) it is
matching, but it is discarding the event.
Does anyone know how to get this flowing correctly? I am running
Netview 7.1.4 on Windows 2000, and the TEC Server (3.9) is loaded on the
same server.
Thanks,
Brian
Brian W. Green
IBM Certified Deployment Professional
CGI Information Systems and Management Consulting
275 Slater Street, 14th Floor
Ottawa, Ontario
K1P 5H9
(613) 234-2155
brian.green@cgi.com
|