Hi
Normally which you compile the mibs, Netview will/should load the all the trap
definitions supllied with the specific mib. So try and load the mibs...
Vynita Pretorius wrote:
> -- [ From: Vynita Pretorius * EMC.Ver #2.5.02 ] --
>
> Hi
> When you say you are looking up Trapd.conf I presume you are looking at the
> trapd.conf that appears in /usr/OV/conf/C because in my experiences the
> trapd.conf in /usr/OV/conf does not update. Have you checked to see the
> actual traps in xnmtrap.
> B.T.W. There is a utility xnmevents and UpdateTrapXXX which merges a file
> into the trapd.conf, BUT if think it is part of the Ciscoview/works package.
>
> Thanks
> Vynita Pretorius
>
> -------- REPLY, Original message follows --------
>
> > Date: Tuesday, 27-Oct-98 09:29 AM
> >
> > From: James_Shanks@TIVOLI.COM \ Internet: (james_shanks@tivoli.com)
> > To: Multiple recipients of list NV-L \ Internet: (nv-l@ucsbvm.ucsb.
> edu)
> >
> > Subject: Re: Problem with nvaddtrapdconf
> >
> > Are you getting any messages at all? You should get at least a
> "successful"
> > message.
> >
> > The only thing I can think of is that your trapd.conf does not have an
> > enterprise entry for this vendor. If not, you will have to add that first
> by
> > xnmtrap, or put it into the vendor file as the first item. But whenever I
> have
> > this problem, I do get an error message. If you cannot get it to work,
> then
> > you'll have to call Support.
> >
> > James Shanks
> > Tivoli (NetView for UNIX) L3 Support
> >
> >
> >
> > "R.V." <vishwa@INDUS.HCLT.COM> on 10/26/98 02:07:16 AM
> >
> > Please respond to Discussion of IBM NetView and POLYCENTER Manager on
> > NetView <NV-L@UCSBVM.UCSB.EDU>
> >
> > To: NV-L@UCSBVM.UCSB.EDU
> > cc: (bcc: James Shanks)
> > Subject: Problem with nvaddtrapdconf
> >
> >
> >
> >
> >
> > Hi all,
> > I am new to NetView. I have
> > a problem when merging the Vendor
> > supplied
> > trap definitions into the trapd.conf
> > file using the nvaddtrapdconf shell
> > script. No error
> > msg's occur . But when I look up the
> > trapd.conf file after running the script
> > no Vendor supplied definitions have been
> > actually added. I don't understand
> > what's happening.Can any one help me out
> > , please ?
> > Thanx in Advance.
> >
> >
> > - Regards
> >
> > Vishwa
> >
>
> -------- REPLY, End of original message --------
|