APAR IX66302 says there was an attempt to fix this in U449573.
If you are not at the current level of code for NetView V4, which is
U459387, I would advise you to get there, and call Support if your problem
persists. But be aware that V4 is already out of support.
James Shanks
Tivoli (NetView for UNIX) L3 Support
Mario Beck <mariobeck@GMX.NET> on 12/16/98 09:56:05 AM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on
NetView <NV-L@UCSBVM.UCSB.EDU>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: James Shanks)
Subject: Select failed; error code 9
Hi,
I've the following problem:
When I try to read out a SNMP device by the MIB browser, sometimes there
is the warning output in the nv6000.log and the aixterm (tee nv6000.log):
Warning: Select failed; error code 9
Warning: Select failed; error code 9
Warning: Select failed; error code 9
...
I cannot stop this output.
I cannot close the MIB browser window normaly.
When I close the NetView GUI the output doesn't stop.
Our installation:
AIX 4.2.1
NetView 5.0
NWays 1.2.1
Is there a workaround or a PTF?
Thanx & Bye
---
Sent through Global Message Exchange - http://www.gmx.net
|