After updating oid_to_type you need to stop netmon, run a ovtopofix -a
-o <sysObjectId you just updated> and restart netmon or just wait for
the next configuration poll by netmon.
- Michael.
______________________________ Reply Separator _________________________________
Subject: Re: resetting "vendor" field
Author: Non-HP-Joe.Prokott (Joe.Prokott@WESTGROUP.COM) at HP-Belgium,mimegw3
Date: 13-05-99 22:07
I am looking for a way to reset this "vendor" field via the parameters
defined in the oid_to_type file. I want to avoid rediscovery of the node,
however, to do this. We have several devices that need to go from "Unset"
to "Cisco Systems". Is this possible?
Joe
-----Original Message-----
From: Leslie Clark [mailto:lclark@US.IBM.COM]
Sent: Thursday, May 13, 1999 1:20 PM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: resetting "vendor" field
So see the man page for nvdbimport.
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
This is used to output field values, not reset field values of existing
devices according to definitions defined in /usr/OV/fields/C/ directory.
Joe Prokott - West Group
Network Architect
610 Opperman Drive
St. Paul, MN 55123
Phone: 651-687-4536
Fax: 651-687-6946
E-mail: joe.prokott@westgroup.com
-----Original Message-----
From: Leslie Clark [mailto:lclark@US.IBM.COM]
Sent: Wednesday, May 12, 1999 10:14 PM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: resetting "vendor" field
See nvdbformat man page.
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Is there anyway to reset the "vendor" NV field without rediscovering the
device and without having to reset each node manually via the GUI?
Thanks,
Joe Prokott - West Group
Network Architect
610 Opperman Drive
St. Paul, MN 55123
Phone: 651-687-4536
Fax: 651-687-6946
E-mail: joe.prokott@westgroup.com
|