My initial event stream is set to BLOCK.
I'l try that netstat stuff next time this happens.
/Christian
-----Original Message-----
From: James Shanks [mailto:James_Shanks@TIVOLI.COM]
Sent: Friday, May 21, 1999 4:11 PM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: Events not showing
Does your ruleset in ESE.automation have the initial event stream node (the
"purple pizza") set to PASS rather than BLOCK?
Do a netstat -a and look to see if the send and receive queues of some
process connected to nvcorrd are filling up with
rather large values (normally the queues are zero or close to it). If you
see that then ovstop actionsvr, which will de-register your ruleset in
ESE.automation. Wait a minute and then do another netstat -a. Does the
problem go away? If so, then your ruleset is the most likely suspect, and
the problem is most likely the one above.
James Shanks
Tivoli (NetView for UNIX) L3 Support
Frantsen Christian <cf@INTERNOC.SE> on 05/21/99 08:15:09 AM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on
NetView <NV-L@UCSBVM.UCSB.EDU>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: James Shanks/Tivoli Systems)
Subject: Re: Events not showing
It's the event window I was talking about (sorry)
I have one rule running that waits for a node up event to appear within a
specified amountof minutes of a node down and if not, makes a popup-window
on my desktop. That's all i have running in the ESE.automation.
/Christian
-----Original Message-----
From: James Shanks [mailto:James_Shanks@TIVOLI.COM]
Sent: Friday, May 21, 1999 2:02 PM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: Events not showing
Event log? Which do you mean, in the events window or in trapd.log? Or
the ovevent.log?
If you mean the events window, do you have any rulesets running out of the
file /usr/OV/conf/ESE.automation?
If so, what do they do?
James Shanks
Tivoli (NetView for UNIX) L3 Support
|