Hi,
Occasionally some pings from netmon deamon do not reach the nodes.
There is no specific pattern about the nodes and time it occurs. It is all
at random. Most of the nodes are Cisco routers (less than 60 routers) spread
out around the world.
When you see the trapd.log file there are many one-minute 'Interface
down/up' events from different nodes. The polling interval is one minute.
The retry has been set to 5 times at 10 sec interval.
In addition, if you ping the node from the map at the same time this
problem occurs (you see it red on the map), Netview 'realizes' about the
mistake and changes the status to normal inmediately.
Does anybody experience the same problem?
IBM tech support checked our RS6000 and it's OK. Besides we have
another monitoring platform using the same Catalyst Switch that it's
connected our RS6000 and it works OK.
Our RS6000 P240 has 768MB RAM, 9.1Gb disk and dual processor.
Thanks and regards...
Gabriel Belforti
baibeg@techint.net
TE: +54-11-4318-2384
FAX: +54-11-4318-2690
VIDEO (ISDN): +54-11-4591-2000 (x2)
http://www.techintgroup.com
|