try this tip:
If you run into the case where you have put a product or patch on the Framework,
and
you then try to install a patch or product that is older and you get the error
message that
the patch or product is subsumed, you may recover by doing the following.
1. Remove all reference to the patch or product in your managed node .installed
files.
2. The error is Product and or patch has been subsumed:
wlookup -ar PatchInfo
3.1-TMP-0002 1997933334.1.485#TMF_Install::PatchInfo#
Inventory_3.1 1997933334.1.683#TMF_Install::PatchInfo#
TMF_3.1_SP1 1997933334.1.511#TMF_Install::PatchInfo#
wregister -u -r PatchInfo Inventory_3.1
This will unregister the patch Inventory_3.1
wlookup -ar ProductInfo
This will give you a listing of currently registered products.
wregister -u -r ProductInfo Inventory_3.1
Now you should be able to go back and install the older patch and product.
Andre Faille <Andre.Faille@SITA.INT> on 12/01/99 11:43:57 AM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
<NV-L@UCSBVM.UCSB.EDU>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: Bill Jameson/Tivoli Systems)
Subject: Removing a patch from FrameWork/Netview?
hi all,
Is there a way to remove a patch that was installed on Framework or on Netview
selectively? ( like the NVTMP311 patch )
thanks,
Andr
é Faille
LAN Management Analyst, Computer Desktop Management Team
SITA - EQUANT
770, Sherbrooke West 21st floor, Montreal, Quebec, Canada H3A 1G1
Phone: (514) 985-3743 or CVS 7 225 3743 Fax: (514) 847-3400
andre.faille@sita.int / http://www.sita.int
|