Cancel out and start over. There is a problem with the MIB you are trying to
load. Just trying it again will cause another temp copy of it to be added to
the one which you already have and throw off the line numbers. So the rule of
thumb is - whnne you get an error, quit. Then examine the MIB and see if you
can figure it out.
James Shanks
Team Leader, Level 3 Support
Tivoli NetView for UNIX and NT
"Treptow, Craig" <Treptow.Craig@principal.com> on 08/09/2000 09:07:55 AM
Please respond to IBM NetView Discussion <nv-l@tkg.com>
To: "NetView List (E-mail)" <nv-l@tkg.com>
cc: (bcc: James Shanks/Tivoli Systems)
Subject: [NV-L] MIB table is bad?
Hi. In Netview 6.0, I was trying to load some MIB's just now and received:
"Error detected while loading MIB File: <MIB file>. This MIB cannot be loaded
until the following problem is corrected:
Bad operator: On or around line -4305
Mib table is bad.
Bad operator: On or around line 44850
Mib table is bad.
Every attempt to load a MIB results in this message with two new lines
referencing different line numbers that are larger than the previous.
So what file has the problem?
Craig Treptow
Principal Financial Group
I/S Network Administration
(515) 247-6207
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|