Hi,
We have Netview Unix 6.0.1 on Solaris 2.7.
I've had a problem occur a couple of times where Netview in its infinite
wisdom creates new entries in the ovsnmp.conf_db database for individual
nodes, using Netview defaults but with community names not found anywhere
except in the managed device itself.
For example, we use public for all our read-only monitoring but use say
"xyz" as our read-write community name.
I setup the ovsnmp.conf_db with only static entries for our two Netview
boxes, and either the default or a smartset entry for every other managed
node.
Our default is:
*.*.*.*:public:*:100:2:7200:::604800:604800:86400:10:1:0:1
Our smartset entries are similar but with slightly different timeout
settings, depending on the set.
branch_swch:public:*:200:2:7200:::604800:2419200:86400:1:0:0:0
I've found two occasions where entries are created like:
hostname1:xyz::::::::::::
It's only happened twice, and it has happened when nobody has been using
Netview, just the daemons in the background doing polling. Entries haven't
been created for EVERY managed node - just some.
Unfortunately, the above settings cause high CPU usage on our smaller Cisco
routers, which I think is due to netmon wanting to get the entire routing
table and with a small timeout, retries occur.
I Netview designed like this and if so why?
Regards,
Peter Anderson
Senior Communications Analyst
Westpac Banking Corporation
Ph: 0011 61 2 99025938
<Remove ETER from my address to reply>
Any views or opinions presented are solely those of the author and do not
necessarily represent those of Westpac Banking Corporation.
|