you can put up to 6 community name in the file "communityNames.conf" netview
will check for all the community you put in this file. but i'm not sure if
he found one that its working if it continue
with the others community ..... but you can look at this files for the
configuration...
Dominic
-----Message d'origine-----
De?: Fission CC Lin [mailto:flin@tw.ibm.com]
Envoye?: 10 mai, 2002 06:15
A?: nv-l@lists.tivoli.com
Cc?: Adam CW Cheng; EricHung@ncic.com.tw; Carlos@ncic.com.tw
Objet?: [nv-l] MIB data collection on community string index device
Importance?: Haute
Dear all,
My customer has a Layer-4 switch named Nortel Passport 8600, and insert
a WSM module on it. If I want to get the SNMP information about Passport
8600, I need to use community name A; if I want to get the SNMP information
about the WSM module, I need to use community name B, to the same IP
address. My problem is that in Netview I could set only one community name
for a specific IP, but in this case, there are two community names
correspond to two different devices on the same IP, in other words, I could
get SNMP information about one of them at the same time. My customer would
like to collect the MIB information of "both" ( use the data collection
function of Netview ), how should I do? any hints may help, thanks........
Best Regards,
Fission Lin, 林倩全
I / T Specialist , Tivoli Professional Services,
ITS/SMBU/NSM, IBM Taiwan
206, Sec.1 Keelung Rd, Taipei, Taiwan, R.O.C.
Tel:886-2-2725-8872, Mobile:0935-558622
E-Mail: flin@tw.ibm.com
|