[Top] [All Lists]

[nv-l] Re:How to certify the completion of MIB.

To: nv-l@lists.tivoli.com
Subject: [nv-l] Re:How to certify the completion of MIB.
From: "Francois Le Hir/Quebec/IBM" <flehir@ca.ibm.com>
Date: Wed, 19 Jun 2002 13:02:27 -0400

As explained in the man page of snmpwalk, the "End of Mib" is normal when
we reach the end of the mibs that are supported for this device.
Its not about the mibs that are loaded in Netview but about the mibs that
the device support. If netview didn't get you an error message, then the
mib is properly loaded.

man snmpwalk
"If there is an attempt to search beyond the end of  the  remote
 node MIB, with snmpwalk or snmpnext, the message End of MIB is displayed."


Francois Le Hir
Network Projects & Consulting Services
IBM Global Services
Phone: (514) 205 6695

Date: Tue, 18 Jun 2002 10:58:17 -0400
To: "'nv-l@lists.tivoli.com'" <nv-l@lists.tivoli.com>
From: "Amjad Asif (tel2axa)" <tel2axa@ups.com>
Subject: How to certify the completion of MIB.

Hello Folks ,

Netview 7.1.0 on AIX 4.3.3.

                 I loaded the MIBs of Nokia in Netview .How do I certify
that I loaded the complete MIBs of the product?
When I did the snmpwalk on the nokia device at the end it says "END OF MIB
what does that mean?

Any suggestions ?

Kind regards,

Asif Amjad
Network Management Systems
United Parcel Service

<Prev in Thread] Current Thread [Next in Thread>
  • [nv-l] Re:How to certify the completion of MIB., Francois Le Hir/Quebec/IBM <=

Archive operated by Skills 1st Ltd

See also: The NetView Web