You didn't say but is your SP2 node running NetView using the switch at
all?
If you have an external ethernet the I would check on disabling kerberos,
which is supposed to only be involved in the "r-commands", ie. rsh, rlogin,
rcp.
If you are using the switch adapter, then you must be using another node
as a router or the switch router. In both cases, check that the no
parameters on your SP2 node are set for the switch and not for an ethernet
or vice versa depending on what interface NetView is using.
Also, insure that your adapters are set for 100Mb/s full-duplex (or 10
Mb/s if that's your ethernet adapter card's speed) and not to
Auto-Negotiate.
Regards,
ken
|