Hello list,
Netview 7.1.2 on AIX 4.3.3ML09
with the Web Interface of Netview, it is possible to restrict the view of a
given map to some users by allowing them access to some networks and/or
locations.
This works by listing all networks/locations they are allowed to view. This
is good when the list is short.
My question is : is it possible to define the following "give access to the
whole map but NOT to some networks/locations without having to list all what
they're allowed to. This would give a very long list and one would never be
sure this list is up to date (some new networks can always be discovered by
netmon)".
so to summarise : it is possible to define negative entries in the scope
instead of positive entries ?
many thanks for any advise.
Bernard Baudoux.
Network Management
Telecommunication / 1GA2H
Fortis Banque
Tel : +32 (0)2 565 24 68
Fax : +32 (0)2 228 83 69
bernard.baudoux@fortisbank.com
This email and any attached files are confidential and may be legally
privileged.
If you are not the intended recipient, any disclosure, reproduction,
copying, distribution, or other dissemination or use of this communication
is strictly prohibited.
If you have received this transmission in error please notify the sender
immediately and then delete this email.
Email transmission cannot be guaranteed to be secure or error free as
information could be intercepted, corrupted, lost, destroyed, arrive late or
incomplete, or contain viruses.
The sender therefore is in no way liable for any errors or omissions in the
content of this message, which may arise as a result of email transmission.
If verification is required, please request a hard copy.
<<application/ms-tnef>>
|