"Maxime TRANNOY" <MTRANNOY@fr.ibm.com> writes:
> Hello,
>
> I have made a fresh install of a netview server in 7.1.3, but this server
> shall forward its trap to a TEC in 3.6.
> In the release note it says to change the Pre37Server flag to the value YES
> in the tecint.conf and stop and start the nvserverd to forwar to a TEC
> server with a version earlier than 3.7.
> I try this but my the TEC still not parse my messages.
>
> What have i missed?
> Do i need to do something on the TEC also?
I _think_ that if you do a fresh install, it may have installed the
new TEC definitions by default even if the flag you mentioned is set.
I'm not entirely sure.
A framework-based upgrade installation will keep the old definitions
by default (at least that was my experience with 7.1.2), but an
interactive upgrade will prompt you to ask if you want to install the
revised TEC class definitions (according a support engineer who
reassured me in my query about a 7.1.0 to 7.1.2 upgrade no breaking my
TEC stuff).
It sounds like the revised definitions were installed. See the 7.1.2
release notes for more details. I'm not sure how to undo it but I
bet Tivoli support would have a procedure for ya.
Best Regards,
--
Todd H.
http://www.toddh.net/
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
For additional commands, e-mail: nv-l-help@lists.tivoli.com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
|