HI all
I have netview aix 7.1.2 aix 4.3.3
I have a router where the serial0 was configured with an ip address but
serial0 had sub interfaces serial0.1 also with ip addr configured. etc
The configuration on the router has been changed so that serial0 has no
ipaddress only the sub interface do.
I demand polled the router but nothing changed the serial0 still appears on
the map and also on ovtopodump, also in the demandpoll output it is still
listing the ip address - why?
The dump says that the config polled occurred when I did the demandpoll, why
has the map not updated ( I have Readwrite)
P.S. What documentation is available for Netview 7.1..?
I can only find the release notes on the web.
Thanks
Vynita
___________________________________________________________________________________________________
The views expressed in this email are, unless otherwise stated, those of the
author and not those
of the FirstRand Banking Group or its management. The information in this
e-mail is confidential
and is intended solely for the addressee. Access to this e-mail by anyone else
is unauthorised.
If you are not the intended recipient, any disclosure, copying, distribution or
any action taken or
omitted in reliance on this, is prohibited and may be unlawful.
Whilst all reasonable steps are taken to ensure the accuracy and integrity of
information and data
transmitted electronically and to preserve the confidentiality thereof, no
liability or
responsibility whatsoever is accepted if information or data is, for whatever
reason, corrupted
or does not reach its intended destination.
________________________________
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
For additional commands, e-mail: nv-l-help@lists.tivoli.com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
|