Re: [nv-l] Varbind for Host-address

[Leslie Clark <lclark@us.ibm.com>]

This information is from the release notes and applies to V7.1.2 or better: 

New Variable Bindings for Tivoli NetView Traps
New variable bindings (varbinds) have been added to the following Tivoli NetView traps:
-Subnet Unreachable and Subnet Reachable Again events - varbind 7 will contain the network address of the subnet and varbind 8 will contain the subnet mask.
- All interface events - varbind 7 will contain the IP address of the interface and varbind 8 will contain the interface object ID. This is used to uniquely identify
the interface on a given node.
- All node events - varbind 7 is empty (unused) and varbind 8 will contain a comma-separated list of the IP addresses of all the interfaces on the node.
- All router events - varbind 7 and 8 are unused.
- All Layer 2 Status events - varbind 7 is empty (unused), varbind 8 is empty (unused), varbind 9 contains the subnet IP address, and varbind 10 contains the subnet mask.

There is more about this in the Admin Guide in the online books. Be sure to install the online books component. 

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit

nraaman@chennai.tcs.co.in Sent by: owner-nv-l@lists.us.ibm.com 01/05/2004 11:25 PM Please respond to nv-l

To:        nv-l@lists.us.ibm.com         cc:                 Subject:        [nv-l] Varbind for Host-address

Hi,

At present i not able to intergrate wioth TEC. So i involved in generating alert from
NetView directing using sendmail utility. How to get the Interface IP address from the
NetView event.

Please help us ASAP...

Thanks & Regards
N.Raaman(Ramamoorthy)
Asst.Engineer,
NOC(JNR)-Chennai,
Ph:044-23624248
Extn: 5100,5101





#### InterScan_Disclaimer.txt has been removed from this note on January 06, 2004 by Leslie Clark