Re: [nv-l] APM Question.

[Leslie Clark <lclark@us.ibm.com>]

The color change will take place in
the APM topology on the root level of the map. If you look in there, you
should see a collection for each policy. In each of those, the nodes that
have the policy set for them are shown, and the status of those nodes is
the status of the policies.
There are events for the state change,
and by default they are 'log only', I believe. You can change those to
something else so they show up in the events display. The Enterprise is
Tivoli/MLM_Threshold {1.3.6.1.4.1.2.6.12.5.1}.

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
(248) 552-4968 Voicemail, Fax, Pager

alejandro.gabay@reuters.com
Sent by: owner-nv-l@lists.us.ibm.com

11/09/2004 05:44 PM

Please respond to
nv-l

To	nv-l@lists.us.ibm.com
cc
Subject	[nv-l] APM Question.

Hi All.
We are running Netview 7.1.4 FP2 on Solaris 8.
We are using APM to monitor some special interfaces.
Altough we see in MLM Configuration Application that the devices goes to
the armed state when the specified threshold is met. We do not receive
any notification neither map color change in Netview. Although I can set
actions to do that , I wonder if MLM should notify netview when an APM
threshold occurs. Does anyone have a clue where might be the problem located?.

B. Regards
Alejandro Gabay
Operation Supervisor, Argentina, Uruguay & Paraguay
Reuters Ltd.




-----------------------------------------------------------------
        Visit our Internet site at http://www.reuters.com

Get closer to the financial markets with Reuters Messaging - for more
information and to register, visit http://www.reuters.com/messaging

Any views expressed in this message are those of  the  individual
sender,  except  where  the sender specifically states them
to be
the views of Reuters Ltd.