RE: [nv-l] cannot get the object in map

["Glen Warn" <Glen.Warn@pemcocorp.com>]

Have you tried adding that router to the seedfile?  If not, you can access it by going to Options - Netmon Seed Editor.  Highlight set initial discovery seeds - then hit add and either enter the IP or the hostname (make sure it's the "nearest hop" interface though).  Just hit save and answer yes when asked to update the network monitor.  Try a ping a few seconds later and typically it will appear.  I've had many nodes on the back side of firewalls and VPNs where this is the only way to get them discovered.

 

Good luck,

 

Glen Warn

PEMCO Corporation Computer Services (PCCS)

glen.warn@pemcocorp.com

206-628-5770

 

---

From: owner-nv-l@lists.us.ibm.com [mailto:owner-nv-l@lists.us.ibm.com] On Behalf Of praveen
Sent: Thursday, May 26, 2005 3:08 AM
To: nv-l@lists.us.ibm.com
Subject: [nv-l] cannot get the object in map

Hi List,

 

I am running Netview 7.1.4 server in windows ,from my network I had an another connection to my companies branch office ,the connection I am using to this remote location is through the internet ,I can do a SNMP walk to this remote router I can also ping it still it is not discovered   ,as it is through a public network will it prevent from discovering it ,I tried seed file too. but of no chance, I am able to view it through MRTG

Any body have any suggestions, all are welcome

Thanks in advance

 

 

Praveen Kumar

  Global Network Operations Centre (GNOC)

  US Technology

  Bhavani 4^th Floor

  Technopark Campus Trivandrum

  Phone : +91 471 233 577 ext 8651

  Mobile: +91 9349140942