Fw: [NV-L] Predefined configurations from SNMP Collector NOT showing

[John Thomas <johnt@us.ibm.com>]

Did you install NetView on a disk drive
other than C:\?  If so, your nvcollector configuration may not be
correct.  The solution is to open a command prompt, make your NetView
disk the current disk, and then run the nvCollConfig.bat utility again.
 It is probably a good idea to switch to snmpCollect first and then
back to nvcollectord.

John Thomas SWG Client Support - Software NetView Distributed Level 2 Customer Support johnt@us.ibm.com

----- Forwarded by John
Thomas/Raleigh/IBM on 05/14/2007 02:26 PM -----

Mario Behring <mariobehring@yahoo.com>
Sent by: nv-l-bounces@lists.ca.ibm.com

05/12/2007 04:25 PM

Please respond to
Tivoli NetView Discussions <nv-l@lists.ca.ibm.com>

To	NetView List <nv-l@lists.ca.ibm.com>
cc
Subject	[NV-L] Predefined configurations from SNMP Collector NOT showing

Hi list,

I've installed NV 7.1.5 on a Windows 2003 Server SE box and selected the
nvcollectord option from the installation wizard. The installation was
ok and the product is working fine. 

However, the predefined Expressions that are supposed to appear when you
are configuring a SNMP collection are not showing.......the _expression_
window remains empty no matter which Smartset you select.

Any help is appreciated.

Thank you.

Mario

---

It's here! Your new message!
Get new
email alerts with the free Yahoo!
Toolbar._______________________________________________
NV-L mailing list
NV-L@lists.ca.ibm.com
Unsubscribe:NV-L-leave@lists.ca.ibm.com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to
internal IBM'ers only)
_______________________________________________
NV-L mailing list
NV-L@lists.ca.ibm.com
Unsubscribe:NV-L-leave@lists.ca.ibm.com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to 
internal IBM'ers only)