Todd - after sending some of these 3rd party traps (cisco/netware etc), try
running the "wtdumprl" command from your tec server. If you see the data
from the 3rd party traps with a message like "COULD NOT PROCESS" at the
end, this means trapd is doing it's job and you need to get the proper
baroc files loaded (which comes back to your original question about
nvserverd_event)
If you do not see any of this data, than it could be the problem James
mentioned where trapd is not even forwarding these traps.
Jason
"Todd E. Lewis" <telewis@PROVIDENTBANKMD.COM> on 06/01/99 10:12:47 AM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on
NetView <NV-L@UCSBVM.UCSB.EDU>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: Jason Kravitz/Tivoli Systems)
Subject: Re: Netview Nt 5.1.1/Baroc files for TEC
I have the Tec adapter loaded but it only sends traps that are
netview-related, in other words I don't get netware/cisco/bay specific
traps being sent to TEC from netview.
>>> James Shanks <James_Shanks@TIVOLI.COM> 06/01 9:23 AM >>>
I am not an expert on NT doc so I don't know what you are reading, but the
files you are talking about are for the UNIX version only. Since there is
no nvserverd in NT, there is no nvserverd event, and hence no .baroc and no
.rls. Look in your NT release notes. You should find mention of how to
install the NT TEC adapter, which is way different than the internal
NetView one supplied with UNIX.
Good luck
James Shanks
Tivoli (NetView for UNIX) L3 Support
"Todd E. Lewis" <telewis@PROVIDENTBANKMD.COM> on 05/28/99 04:45:44 PM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on
NetView <NV-L@UCSBVM.UCSB.EDU>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: James Shanks/Tivoli Systems)
Subject: Netview Nt 5.1.1/Baroc files for TEC
>From what I understand, when you run mib2trap a baroc file is created. This
baroc file needs to be imported and compiled into a rule base on TEC.
However there seems to be a class problem with an error about
nvserverd_event missing. Does anyone know where this file
nvserverd_event.baroc and nvserverd_event.rls are located. They are
supposed to be on the netview server under \usr\ov\conf. A document that I
found states that these came with netview 5.0 and should be imported along
with any other baroc files created in netview. Any help would be
appreciated.
Ps: These files don't come with 5.1 or 5.1.1
|