Take a look at out "Snmp Data Collection and Thresholds"
-----Original Message-----
From: Gerry Thome [SMTP:thome@BERBEE.COM]
Sent: Monday, September 27, 1999 5:09 PM
To: NV-L@UCSBVM.ucsb.edu
Subject: Re: pooling interval
Along the same lines, xnmsnmpconf the only place where SNMP configuration
polling settings are set? Some of my networking switch folks are telling me
the Xylan switch is getting pounded every 20 minutes by SNMP queries.
They ran a sniffer to determine the source and type of traffic.
I cannot find a 20 minute polling interval in xnmsnmpconf. Is there
somewhere else I should be looking?
--
Gerry Thome
Berbee Information Networks
thome@berbee.com
(920)997-9420 x 51
-----Original Message-----
From: James Shanks [SMTP:James_Shanks@TIVOLI.COM]
Sent: Monday, September 27, 1999 3:41 PM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: pooling interval
Yes, type in xnmsnmpconf from the command line or pull down Options ... SNMP
Configuration from the GUI and you can change the polling interval for any
interface you like. You can also set options by using IP address ranges
(called wildcards) and by collection. Use the Help for more information
James Shanks
Tivoli (NetView for UNIX) L3 Support
Bartosz Gajda <gajda@man.poznan.pl> on 09/27/99 12:43:16 PM
Please respond to Bartosz Gajda <gajda@man.poznan.pl>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: James Shanks/Tivoli Systems)
Subject: pooling interval
Hello Everyone!
I am quite new on this list, so please forgive me if this problem was
solved before, but It is very urgent for me.
Is it possible to poll specyfic interace with specyfic interval of time
(diffrent than the rest of the network)?
Netview 5.0 & AIX 4.2
Thanks!
Bartosz Gajda
Poznan Supercomputing and Networking Center
POLAND
|