THanx for the info.
I found a private mib that may be of use. locIfInPktsSec and
locIfOutPktsSec.
So if I understand you correctly, if I want to monitor collisions on the
Cisco's Ethernet interface i should just convert the locIfCollisions to
Pkts/sec and then divide the result with locIfOutPktsSec?
/Christian
-----Original Message-----
From: Joel A. Gerber [mailto:joel.gerber@USAA.COM]
Sent: Tuesday, November 02, 1999 8:55 PM
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: Cisco Collisions
To get a percentage, you need to divide by the number of packets. I don't
know if there is a private Cisco MIB for that or not. We usually use the
sum of the public MIBs if InUcastPkts, ifInNUcastPkts, ifOutUcastPkts and
ifOutNUcastPkts. Maybe you could just use the two ifOut* MIBs since
collisions only occur on transmitted packets.
Joel Gerber - I/T Networking Professional - USAA Information Technology Co.
- San Antonio, TX
"Tell me what you need, and I'll tell you how to get along without it."
Dilbert's Words of Wisdom
-----Original Message-----
From: Frantsen Christian [SMTP:cf@INTERNOC.SE]
Sent: Friday, October 29, 1999 03:07
To: NV-L@UCSBVM.UCSB.EDU
Subject: Cisco Collisions
Hi!
If I want to find out the collision % on a cisco router what packet
counter
should i use?
Since the locIfCollisions in the cisco-MIB is messured in total
number of
packets, *Octets won't be correct right? I can't seem to find a
MIB-variable
that counts the total number of packets (like etherStatsPkts from
the
RMON-MIB). I assume, that is the type of counter I need.
-----------------------------------------
Christian Frantsen
Technical Operations
Internoc Scandinavia AB
Tel: +46-36-194843
Fax: +46-36-194651
http://www.internoc.se
|