Well, I only see a distinction between 'discovery' and 'configuration
poll'.
I think 'initial' and 'discovery' are redundant terms. It is possible that
on NT,
where these terms are used, they mean something more, but I doubt it.
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit
Hlave? Josef <hlaves@datasys.cz>@tkg.com on 09/05/2000 02:40:03 AM
Please respond to IBM NetView Discussion <nv-l@tkg.com>
Sent by: owner-nv-l@tkg.com
To: "'IBM NetView Discussion'" <nv-l@tkg.com>
cc:
Subject: RE: [NV-L] communitynames.conf seems not to work properly for NV
6.01 for N T.
Hi Leslie
many thanks for your help. But I would like to ask another question. What
is
the diffrence between initial a "normal" discovery a when the initial
discovery finishes and the "normal" discovery begins.
Best regards
Josef Hlaves
-----Original Message-----
From: lclark@us.ibm.com [mailto:lclark@us.ibm.com]
Sent: Monday, September 04, 2000 8:23 PM
To: IBM NetView Discussion
Subject: Re: [NV-L] communitynames.conf seems not to work properly for
NV 6.01 for N T.
This is working fine for me. There is an option to say whether to use the
alternates only on initial discovery. Perhaps your devices were discovered
once as non-snmp nodes before you added the names? You could change
the setting (on Discovery, I think) to use it all the time for a while (it
takes more
overhead), and demand-poll some of the nodes. Or delete them and
rediscover them. When I had to add a new community string to the file after
some nodes were discovered as non-snmp, I only had to demand-poll them
and then they changed into routers. I believe mine is set to only use it on
initial discovery.
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit
Hlaves Josef <hlaves@datasys.cz>@tkg.com on 09/04/2000 12:19:17 PM
Please respond to IBM NetView Discussion <nv-l@tkg.com>
Sent by: owner-nv-l@tkg.com
To: nv-l@tkg.com
cc:
Subject: [NV-L] communitynames.conf seems not to work properly for NV 6.01
for N T.
Hi
I have five read community names for all routers in my network. I entered
the community names in the file communitynames.conf.
But the routers haven't been discovered at all.
I must write down my community names for each router by means of SNMP
option
to make NetView discover my routes properly.
I would greatly appretiate if somebody tell me how to make use of the file
communitynames.conf properly for discovery process.
Many thanks
Josef Hlaves
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|