At 12:17 PM 08-12-00 +1100, Ronald Ng wrote:
>>>I have problems loading HP MIB tables on Netview.
>The error message is :
>"Error detected while loading MIB File: /usr/OV/snmp_mibs/hpicfoid.mib.
>This MIB cannot be loaded until the following problem is corrected:
>Line 10: Error defining object: found 'MODULE-IDENTITY'
>
>So I gather its a parsing error and perhaps the keyword isn't defined
>anywhere, but I can't locate which MIB I should lod before that.
Yes, the MIB loader is saying it cannot resolve 'MODULE-IDENTITY'........
>
>Here are the first few lines of it:
>" HP-ICF-OID DEFINITIONS ::= BEGIN
>
> IMPORTS
> enterprises, MODULE-IDENTITY, OBJECT-IDENTITY
> FROM SNMPv2-SMI;
>
....and this IMPORTS statement says MODULE-IDENTITY is in SNMPv2-SMI
So you need to load this first. It is in RFC2578, which should be in your
HP MIB distribution.
Then load your HP MIB file and try browsing objects in it.
>When I do browse the messages come up saying "Sending SNMPv1
>request to x.y.z.a" and some time later it will come back with "SNMP Error:
>SNMPAPI_TL_TIMEOUT - No Response before timeout" And the timeout is set up
>60 seconds which is way above what I can telnet and ping to the device.
>
As James Shanks has responded, if an SNMP Get is timing out, it is usually
because the agent is not running or you are using the wrong community
string. Does this agent respond to Gets of standard objects like sysContact?
>Regards,
> Ronald Ng
> Associate Network Specialist - Network Infrastructure Services
> Office : (02) 9937 8351 Mobile : 0401 149 331 Fax: (02) 9937 8100
>
>IBM Global Services Australia
> Level 1, 55 Christie Street
> St. Leonards NSW 2065
>E-Mail : ronaldng@au1.ibm.com
>
Joe Fernandez
Kardinia Software
jfernand@kardinia.com
|