I was informed by someone locally to use the Data Collection & Thresholds:
SNMP for this, but they are using a "'IfIn%util' or 'IfOut%util'" MIB, of
which I don't have. I could create the same results with the formula of
"((((ifInOctets + ifOutOctets) x 8) / (sysUpTime / 100)) / ifSpeed) x 100",
but I'm not sure on how to create this. In Nortels Optivity you can create
a formula from MIBs within the GUI, but I don't see how to do this within
Netview.
Any ideas? Or better suggestions?
Thanks
-----Original Message-----
From: Davis, Donald [mailto:donald.davis@firstcitizens.com]
Sent: Thursday, November 29, 2001 7:05 AM
To: 'IBM NetView Discussion'
Subject: RE: [NV-L] RE: Bandwidth Notification
Dean,
I am doing exactly that.
I have aprox 350 branch sites with FR wan circuits that I collect
BW-Utilization and generate a custom snmptrap if it bursts above 125% of CIR
for 2 consecutive 5 minute polling intervals.
I do not use NetView's snmp data collection because I do not want data on
all interfaces and the Interface instance numbers are all over the place.
I wrote a script that queries just the WAN link, based on the router and the
specific Interface instance number. Then number crunch the delta of the byte
counts and compare them to the last result which I keep in a flat file for
each router. I uses this file with gnuplot to graph BW-Utilization stats for
7 days.
I manually maintain a file containing the router name and link instance
number.
e-mail me direct if you want a copy of the script.
Don Davis
donald.davis@firstcitizens.com
-----Original Message-----
From: Dean Sullinger [mailto:DSullinger@dot.state.az.us]
Sent: Thursday, November 29, 2001 8:24 AM
To: 'IBM NetView Discussion'
Subject: [NV-L] RE: Bandwidth Notification
Ok everyone, I have what I think is a tough one.
We have both 56k and T1 sites at over 300 remote locations, connected via
point to point or frame relay with Nortel routers at the edge. Management
would like to have us setup an alert in Netview that would page us when the
bandwidth on the WAN side at these sites exceeds 80% over a given amount of
time... Let's say 10 minutes.
We are running Netview 6.x on Solaris 8.
Any ideas on how this might be accomplished?
Thanks
--
Dean Sullinger
Arizona Department of Transportation
Information Technology Group
Wide Area Network
Email : dean@dot.state.az.us
Internet: http://www.dot.state.az.us
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
----------------------------------------------------------------------------
--
This electronic mail and any files transmitted with it are confidential and
are intended solely for the use of individual or entity to whom they are
addressed. If you are not the intended recipient or the person responsible
for delivering the electronic mail to the intended recipient, be advised
that you have received this electronic mail in error and that any use,
dissemination, forwarding, printing, or copying of this electronic mail is
strictly prohibited. If you have received this electronic mail in error,
please immediately notify the sender by return mail.
============================================================================
==
|