Look in the MIB Browser under the Netview events.
Node Up/Down
Interface Up/Down
... are the basics.
Hope this helps,
Jason Allison
Principal Engineer
ARINC Incorporated
Office: (410) 266-2006
FAX: (410) 573-3026
-----Original Message-----
From: Brian Green [mailto:brian.green@cgi.com]
Sent: Wednesday, September 11, 2002 2:22 PM
To: Netview Mailing List
Subject: [nv-l] SNMP Status Checking traps
I have read the Administrator's manuals, and I am a little unclear on
something - If I am doing SNMP polling for status of devices, what traps
will netmon generate for an unreachable device, and what trap when a device
is reachable again? I have looked, and other than taking down elements to
see what happens (something frowned upon in the production world!) I am
hoping that someone out there knows this!
Thanks,
Brian
Brian W. Green, TCC
Consultant
CGI InfoSec COE
CGI Information Systems and Management Consulting
275 Slater Street, 14th Floor
Ottawa, Ontario
K1P 5H9
(613) 234-2155
brian.green@cgi.ca
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe@lists.tivoli.com
For additional commands, e-mail: nv-l-help@lists.tivoli.com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
|