Re: [nv-l] MPLS Monitoring / RFI

["Mike Walsh" <Mike.Walsh@us.ing.com>]

Dave,

We suffer from the same thing.  Went to Magnum Technologies (Switch
Corelator folks) and sure enough, they had a fix that builds links between
the remote router and the local router interface (by passing the MPLS
cloud).  You might want to talk to them.

Best of luck,

Mike


Mike Walsh
****Please Note - New EMAIL Address  mike.walsh@us.ing.com*********
612-342-3118


                                                                                
                                                       
                      reamd@Nationwide.                                         
                                                       
                      com                      To:       nv-l@lists.us.ibm.com  
                                                       
                                               cc:                              
                                                       
                      03/04/2004 09:14         Subject:  [nv-l] MPLS Monitoring 
/ RFI                                                  
                      AM                                                        
                                                       
                      Please respond to                                         
                                                       
                      nv-l                                                      
                                                       
                                                                                
                                                       
                                                                                
                                                       



Hi All,
         Does anyone out there monitor MPLS (Multiprotocol Lable Switching)
with Router Fault Isolation enabled? I am attempting it and the problem I
am having is when one of these locations go down, netview flags it as
Unreachable and turns the device white as it goes searching for the source
of the problem (which would be out in the internet cloud somewhere). . I
have a smartset setup for Problem Nodes that I added ( 'isUnreachable' =
True) to, but the
white unreachable nodes do not populate this smartset.  Is there something
I could do to fake netview out so that it would actually alarm these nodes?
Any suggestions would be appreciated.

AIX 5.1
7.1.4

Thanks, Dave