|
You
can use the API, but if you have netmon polling that IP device on interval, it
will notice the incorrect status and change it back. Start at "man
OVwSetStatusOnObject", this will give you a start. If you have any
specific questions, feel free to ask. Some statuses are "Reserved" and it
wont allow you to change it via the API (eg Acknowledged), but there are
programmatic ways around that.
Good
luck,
Jason Allison
Principal Engineer
ARINC Incorporated
-----Original Message-----
From:
owner-nv-l@lists.us.ibm.com [mailto:owner-nv-l@lists.us.ibm.com] On Behalf Of
Freeman, Michael
Sent: Tuesday, September 21, 2004 11:25
AM
To: nv-l@lists.tivoli.com
Subject: [nv-l] question about
modifying objects in netview 7.1.3
We are trying to find a way to
modify an object in NetView. If we know the node name, and want to change its
status from say down, to up, because of an additional verification that proved
it was up, how would we go about doing it? Are there any utilities or where
should I look in the API?
Thanks,
Mike
*** Note new e-mail
address
--
Michael J.
Freeman
Netco Government
Services
mfreeman@netcogov.com
--
|