|
Catalina,
I
should mention that these devices are Aironet which was bought by Cisco.
Enterprise used in the SmartSet collection is 1.3.6.1.4.1.9.1.525. (See the
latest Cisco Products MIB file.)
So my
previous note about data collection may not apply to your Cisco access
points.
Sorry
if I confused you.
Ray
Westphal
Enterprise Rent-A-Car.
Hello
Catalina,
We are
using NV to gather signal quality and signal strength for access point
clients. Then we upload the results with NetView snmpColDump and Oracle sqlldr
into Oracle tables where we can run Oracle functions such as average, min, max,
and standard deviation of the signal strength and signal
quality.
Here
are the entries from the snmpCol.conf file .....
MIB .1.3.6.1.4.1.9.9.273.1.3.1.1.3
cDot112ClientSignalStrength units INTEGER R
O CISCO_RCI_Access_Points 600
70.000000 40.000000 xA s 58720263 ALL -
MIB .1.3.6.1.4.1.9.9.273.1.3.1.1.4
cDot112ClientSigQuality units INTEGER R
O CISCO_RCI_Access_Points 600
70.000000 40.000000 xA s 58720263 ALL -
Does
that answer your question?
Ray
Westphal
Enterprise Rent-A-Car
Hello
List,
I cant find the
answer in archive so I am not sure if anyone has encountered this.
Can Netview monitor
the radio side of an access point?
In particular AIX 5.2
Netview 7.1.4 Cisco 1210 Access Points.
We are
monitoring BVI side but we also need to know if the radio goes does. Any
ideas?
Is this a Cisco TAC
or Tivoli Tech question? I haven’t open a ticket with either one just wanting
to know
Thanks,
Catalina
|