Re: [nv-l] Traps from IBM SAN Volume Controller

[Paul <pstroud@bellsouth.net>]

After you ran mib2trap did you actually run the commands that were created?
Did it complete successfully?

Paul


mlelleby@adelphia.net wrote:

> Good morning group-
>
> I have been trying to configure the traps for this device as I have already 
> loaded the MIB, ran the mib2trap to create the addtrap commands to add the 
> traps from the mib into netview.
>
> I then ran an 'event -e FMTCHG' to note the change to the trapd.conf file.
>
> However, when the device sends a trap, it still comes in unformatted.
>
> I have checked the trapd.conf and note that the traps taken from the mib and loaded into netview seem to be correct.  
>
> Any suggestions?
>
>