Paul-
You would be correct. The script that contained the addtrap commands was run
successfully.
If I go into Options>Event Customization..SNMP and look for the Enterprise OID,
I can see the 3 'specific traps' that were contained in the script file created
by the mib2trap command.
Mike-
---- Paul <pstroud@bellsouth.net> wrote:
> After you ran mib2trap did you actually run the commands that were created?
> Did it complete successfully?
>
> Paul
>
>
> mlelleby@adelphia.net wrote:
>
> >Good morning group-
> >
> >I have been trying to configure the traps for this device as I have already
> >loaded the MIB, ran the mib2trap to create the addtrap commands to add the
> >traps from the mib into netview.
> >
> >I then ran an 'event -e FMTCHG' to note the change to the trapd.conf file.
> >
> >However, when the device sends a trap, it still comes in unformatted.
> >
> >I have checked the trapd.conf and note that the traps taken from the mib and
> >loaded into netview seem to be correct.
> >
> >Any suggestions?
> >
> >
> >
>
|