|
Mauro,
NetView escapes special characters in the variables, try something similar to the following in your script (the sed will remove the escape (\)
characters...)
ip=`echo "$2" | sed "s:\\\\\\::g"`
echo
"Node $ip Down"|mail -s "The Node $ip..." mymail
Regards
Colin Mulkerrins
Enterprise Systems Management
An Post
-----Original Message-----
From: owner-nv-l@lists.us.ibm.com [mailto:owner-nv-l@lists.us.ibm.com] On Behalf Of
Mauro
Sent: 21 March 2005 14:26
To:
nv-l@lists.tivoli.com
Subject: [nv-l] Variable
question
Hi
folks,
Running Linux 7.2 with Netview
7.1.4 fixpack 2:
I’ve configured trap to be send by
mail using the Trapd-àcommand for automatic
action:
Echo “Node $2 Down” | mail –s “The
Node $2 …..” mymail
When I receive it the variable $2
is passed with some kind of special character
like
Node 172\.21\.12\.3 (rather than
172.21.12.3)…..
What wrong with it
?
Cheers
Mauro
***********************************************************************************
This e-mail and its attachments, is confidential and is intended for the addressee(s) only. If you are not the intended recipient, disclosure, distribution or any action taken in reliance on it is prohibited and may be unlawful. Please note that any information expressed in this message or its attachments is not given or endorsed by An Post unless otherwise indicated by an authorised representative independently of this message. An Post does not accept responsibility for the contents of this message and although it has been scanned for viruses An Post will not accept responsibility for any damage caused as a result of a virus being passed on.
***********************************************************************************
|