this post was immensely helpful to me - the oid_to_sym file, as pointed out
below, contains instructions on relating a device to a particular symbol.
1) add the entries in oid_to_type and oid_to_sym (as you've done)
2) Add the entries to ovw_fields and snmp_fields (as you've done)
3) Run ovw_fields.exe
4) Restart the console
You should now see the entries at the bottom of the drop down list for
the vendor and agent.
Question: Is editing the ovw_fields and snmp_fields the proper way to
add vendors/agents? I read that you're supposed to create your own Field
Registration Files rather than editing the standard Netview FRF's. If so
how do you add entries to an enumeration data type as is required?
Regards,
Matt Moore
>-----Original Message-----
>From: Leslie Clark [SMTP:lclark@US.IBM.COM]
>Sent: Wednesday, 12 May 1999 09:11
>To: NV-L@UCSBVM.ucsb.edu
>Subject: Updating agent and vendor lists on Netview NT 5.1
>
>What am I doing wrong? I have added vendors and agents to ovw_fields and
>snmp_fields as I do on AIX, and I can use them in oid_to_type, but I cannot
>seem to get those additions to show up in the lists of vendors and agents
>in the properties dialog, and even if I delete and rediscover the nodes,
>those
>fields remain unset. Ideas? (I did not see any reported problems on this)
>
>Cordially,
>
>Leslie A. Clark
>IBM Global Services - Systems Mgmt & Networking
>(248) 552-4968 Voicemail, Fax, Pager
> -----Original Message-----
> From: Boyles, Gary P [SMTP:gary.p.boyles@INTEL.COM]
> Sent: Thursday, May 20, 1999 10:50 AM
> To: NV-L@UCSBVM.ucsb.edu
> Subject: Re: Netview NT 5.1.1/Optivity 7.01
>
> You probably have to modify your \usr\OV\conf\c\oid_to_sym file,
> and your \usr\OV\conf\oid_to_type file.
>
> Basically, NetView has to be able to relate the object-id
> (i.e. .1.3.6.1.4.whatever) to a specific computer-type in those
> files.
>
> Find out what OID the Bay devices puts out, and add an entry for it
> in those files.
>
> You'll probably have to go thru the discovery process again, though.
>
> Gary Boyles
>
> -----Original Message-----
> From: Todd E. Lewis [mailto:telewis@PROVIDENTBANKMD.COM]
> Sent: Thursday, May 20, 1999 7:08 AM
> To: NV-L@UCSBVM.UCSB.EDU
> Subject: Netview NT 5.1.1/Optivity 7.01
>
>
> Has anyone integrated these two. What's the trick to getting netview to
> correctly identify bay hubs with the right symbols? We have a couple of
> Bay
> FDDI concentrators that appear to get correctly identified.
|