Hi Rob:
Do not worry about it, I have just done the installation only with IBM
2210 support and it looks good
I have some minor problems but I believe that these are only lack of
configuration.
I would like than you give some fine tuning tips beacause the Nways is
using a lot of procesor.
thanks a lot, and regards,
Sergio Cardona.
Rob Rinear wrote:
>
> Actually, I don't think I can help much. I have only seen a little of what
> you describe, and I have not resolved them. I occasionally have NWAYS
> processes eat up all of the CPU and stay that way until I have to kill them
> (I've left it go for days). I've also seen database syncronization take a
> really long time.
>
> Unfortunately, as I stated, I have not resolved these issues. Since they
> are on my "to do list", I'd also like input from any other Nways folks if
> these problems ring a bell.
>
> Rob
>
> -----Original Message-----
> From: Discussion of IBM NetView and POLYCENTER Manager on NetView
> [mailto:NV-L@UCSBVM.UCSB.EDU]On Behalf Of Sergio Cardona F
> Sent: Friday, July 09, 1999 1:20 PM
> To: NV-L@UCSBVM.UCSB.EDU
> Subject: Re: Nways installation
> Importance: High
>
> Hi Rob:
> Thanks a lot for help Us.
>
> I was installing the campus manager component for some devices (2210,
> 8530, 8235, 6611, 8271),and everything was fine in the installation (no
> log, all filesets ok, every green), but when I restarted the NetView
> the cmld daemon did not start, I found that the cmld configuration file
> (/usr/CML/conf/cmld.conf) was not installed, I copied it from another
> demo installation and then the cmld daemons started.
> When the NetView went up I saw a lot of diferent problems: there were
> some nways related process eating all the processor, the main group
> (Nways Device Management) was not correctly created, the routers
> appeared like NetView general routers, and when I tried to run the
> nways aplication over an specific router, it showed an error message (
> I do not remember it) and the database never sincronized.
> I unistalled the nways and when I ran the NetView the ovtopmd daemon
> did not start again, because the client needed the NetView I restored
> the backup.
>
> Thank for your help,
>
> Sergio Cardona.
>
> Rob Rinear wrote:
> >
> > I've installed it a few times, and I'm not aware of any PTF's necessary.
> > The only prerequisites I remember are the Java RTE level and a few bos
> > filesets, but those are in the install notes.
> >
> > Expand on the errors you received, and maybe it will be familiar to some
> of
> > the Nways users on the list.
> >
> > -----Original Message-----
> > From: Discussion of IBM NetView and POLYCENTER Manager on NetView
> > [mailto:NV-L@UCSBVM.UCSB.EDU]On Behalf Of Sergio Cardona F
> > Sent: Friday, July 09, 1999 11:56 AM
> > To: NV-L@UCSBVM.UCSB.EDU
> > Subject: Nways installation
> > Importance: High
> >
> > Hi All:
> >
> > I am installing Nways Manager ver 1.2.3, over AIX 4.3.2 and NetView
> > 5.1.1 our machine is :Risc/6000 H50 with 1Gb RAM.
> > I have had a lot of problems installing, and I am going to restore the
> > system for a fresh backup and reinstall.
> >
> > I appreciate very much any suggestion.
> > for example, I am not sure about if I would need to apply any PTF.
> >
> > Thanks in advance,
> >
> > Sergio Cardona.
|