Well, for what it is worth from me, the NetView internal adapter was designed to
be simpler and easier to use than the tecad_nv6k one. That one had already been
around for a few years before the Tivoli merger, and afterward, NetView UNIX
development was told to design one that was simpler to use and better integrated
with the product. Thus the internal adapter was born and I think it is the
sensible way to go on UNIX. On NT at the moment you have no choice --
tecad_nv6k is only option. That is because the nvserverd daemon does not exist
on N, so the UNIX solution could not be ported directly.
So the decision comes down to this, I think. If you have several NetViews and
some of them are NT, and they must also forward events to TEC themselves, then
you will have to invest some time in learning the tecad_nv6k. The only
alternative would be to have the NT NetViews forward events to a UNIX one and
have the UNIX one talk to TEC. But without the necessity of sending events
from an NT NetView, I'd use the internal one. It's almost a no-brainer.
James Shanks
Tivoli (NetView for UNIX) L3 Support
"Giovannini, Tom" <tom.giovannini@EDS.COM> on 07/09/99 06:24:02 PM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
<NV-L@UCSBVM.UCSB.EDU>
To: NV-L@UCSBVM.UCSB.EDU
cc: (bcc: James Shanks/Tivoli Systems)
Subject: nvserverd vs tecad_nv6k for TEC Integration
We are in the process of converting from HP OpenView NNM to NetView UNIX.
What I am looking for is advise on what is the best way to forward events to
TEC (nvserverd or tecad_nv6k).
My environment is:
Tivoli Framework 3.6 including TEC 3.6
NetView 5.1.1
SMARTS IPFM product (root cause analysis product)
Since I am a new user to Netview I do not have any investment (time,code) in
the use of the tecad_nv6k adapter.
Based on what I have read and some testing it seems to me that the easiest
way to have events forwarded to the TEC is via the nvserverd daemon. The
NetView Ruleset Editor can be use to select events that will be forwarded.
This editor seems easy to use.
The tecad_nv6k adapter requires updating of the cds, oid and conf files.
Before I commit to the use either of these adapters I would like to get some
advise from those that are much more experienced than I in these products.
Are there any differences that should be considered in making this
selection. I will need to forward SMARTS IPFM events to the TEC no matter
what.
Please advise.
Regards,
Tom Giovannini
EDS
Enterprise Management Engineering - South
Address:
5400 Legacy Drive
M/S: A4-1C-38
Plano, TX 75024
Phone: (972) 604-4105 (8-834) Fax: -4776
Internet: tom.giovannini@eds.com
|