Sorry Drew ,
It didnt occur to me that its not supported,thanks for you help anyway.
Ill try what you advised.
regards Arthur
-----Original Message-----
From: Drew Wall [mailto:drwall@TEKSYSTEMS.COM]
Sent: Tuesday, 27 July 1999 00:22
To: NV-L@UCSBVM.UCSB.EDU
Subject: Re: cisco addtrap script
Arthur,
If you are talking about cisco's traps.script;
If you look closely at the script merge_trap is just a call for addtrap.
Their
syntax is off for versions 5.x so you have to run a few test to correct it.
I
think the script is actually missing a flag/switch, its been awhile. Our
system
(dev. system) ran fine after running the corrected script, but we did not
implement it in production.
--
========================================================
Drew Wall
Enterprise Management
TEKsystems
mailto:drwall@teksystems.com
http://www.teksystems.com
========================================================
"Boulieris, Arthur" wrote:
> Hello ,
> I am using netview 5.1.
> I have a cisco script to add all cisco traps to netview version 3 and 4
> which I downloaded from the cisco site.I have made it executable but gives
a
> syntax error when I run it.
> The script uses a merge_trap instead of addtrap command.
> Does any one know if the merge trap is an old netview command and if so
can
> I replace the merge_trap with addtrap in the txt file and run it again,or
> will this destroy my trapd.conf?
> Appreciate any help out there.
>
> thank you Arthur
|