I have a Cisco Catalyst 6509 and have accidentally used the SNMPV1
loader and got the same "Line 25: Error defining object: found
'MODULE-IDENTITY'" error.
Later,
Mark LaFever
-----Original Message-----
From: KGKARASE@hewitt.com [mailto:KGKARASE@hewitt.com]
Sent: Friday, October 13, 2000 11:09 AM
To: nv-l@tkg.com
Subject: FW: RE: [NV-L] Error loading MIB file
Mark,
How were you able to identify the MIB below in question being a SNMPv2
MIB? I
have received similar message below from trying to load vendor MIB's in
the
past.
From: Mark_LaFever@cargill.com on 10/12/2000 01:55 PM
Please respond to IBM NetView Discussion <nv-l@tkg.com>
To: nv-l@tkg.com
cc:
Client:
Subject: RE: [NV-L] Error loading MIB file
Chris,
If you are using the snmpV1 loader to load snmpV2 mibs you will
get this message. Try using the snmpV2 loader in NetView and it should
work. Tools, MIB, SNMPV2, Load and then select the mib file.
Good luck,
Mark LaFever
Network Analyst
Excel Corp.
316-291-2926
-----Original Message-----
From: chrisp@ucia.gov [mailto:chrisp@ucia.gov]
Sent: Thursday, October 12, 2000 10:14 AM
To: NV-L@UCSBVM.ucsb.edu
Subject: FW: [NV-L] Error loading MIB file
I am trying to load a mib file (ENTITY-MIB) for the Cisco Catalyst 6509
and am getting the following error. I don't have a lot of experience
doing this and was wondering if someone could provide some help.
Thanks.
Error detected while loading MIB file ENTITY-MIB.MY
This MIB cannot be loaded until the following problem is corrected
Line 25: Error defining object: found 'MODULE-IDENTITY'
OBJECT IDENTIFIER
OBJECT-TYPE
TRAP-TYPE
::=
________________________________________________________________________
_
NV-L List information and Archives: http://www.tkg.com/nv-l
BDY.RTF
Description: RTF file
|